Sakai SV414, Руководство по ремонту

Страница: 263 / 294

9-048
TROUBLESHOOTING
2-5. Vibration
Check following items before troubleshooting.
No blown fuses and power is applied up to fuses.
Throttle switch must be “FULL”.
Check any ground circuit which belongs to components to be checked.
2-5-1. No vibration occurs
Vibration mode change switch must be “CONT”.
Vibration select switch must not be “ ”.
Reference Fig.: 2-5-1
Check point Check/Cause Action
1. Vibrator Solenoid Disconnect harness and measure resistance of coil.
Standard resistance : 5.1 Ω
If resistance is abnormal, vibrator solenoid is faulty.
•
•
Replace vibrator
solenoid.
2. Vibration Select Switch (1) When starter switch is ON, measure voltage between
vibration select switch terminal 1, 4 inlet wire Y and
chassis ground.
Standard voltage : 12 V or more
(2) When starter switch is ON and vibration select switch is
“ ”, measure voltage between vibration select
switch terminal 2 outlet wire YB and chassis ground.
Standard voltage : 12 V or more
(3) When starter switch is ON and vibration select switch is
“ ”, measure voltage between vibration select
switch terminal 5 outlet wire YR and chassis ground.
Standard voltage : 12 V or more
If above item (1) is OK and item (2) or (3) is NG, vibration
select switch is faulty.
•
Replace vibration select
switch.
3. Throttle Switch (1) When starter switch is ON, measure voltage between
throttle switch terminal 4 inlet wire RY and chassis
ground.
Standard voltage : 12 V or more
(2) When starter switch is ON, measure voltage between
throttle switch terminal 5 outlet wire RW and chassis
ground.
Standard voltage : 12 V or more
If above item (1) is OK and item (2) is NG, throttle switch
is faulty.
•
Replace throttle switch.
4. Vibration Mode Change
Switch
(1) When starter switch is ON, measure voltage between
vibration mode change switch terminal 1 inlet wire RW
and chassis ground.
Standard voltage : 12 V or more
(2) When starter switch is ON, measure voltage between
vibration mode change switch terminal 2 outlet wire Y
and chassis ground.
Standard voltage : 12 V or more
If above item (1) is OK and item (2) is NG, vibration mode
change switch is faulty.
•
Replace vibration mode
change switch.
5. Harness Connecting
Between Terminals
Measure resistance of harness connecting between
terminals.
Standard resistance : 10 Ω or less
If resistance is abnormal, harness is faulty.
•
•
Repair or replace
harness.
•
•
•
•
•