M2 Series Micro-inverter
13
14
3.2.2 Scope of Delivery
Please contact after sales if there is missing or damaged components
Micro-inverter*1
AC trunk cable*1
AC trunk connector unlock
tool*1
AC trunk end cap*1
AC trunk port disconnect
tool
*1
AC trunk port cap
*1
Mounting bracket
*1
(optional)
DC extension cable
*1
(optional)
M8*25 bolts
*2
(optional)
Installation Map
Documents
Micro-inverter SN label
Monitoring SN label
The documents include the user manual, quick installation guide and packaging list.
3.3 Determining the installation method and position
(1) The equipment employs natural convection cooling, and it can be installed indoor or outdoor.
(2) Mount the equipment horizontally on the rail or vertically on the mounting bracket and face the cover
toward the solar panels.
(3) Please hold the handle of the microinverter with your hands. Do not lift the AC cable with bare hands.
Figure 3.1
Holding method
(4) when mounting the inverter, please consider the solidity of the wall or the rail, including accessories. Make
sure the wall or the rail has enough strength to hold the screws and bear the weight of products. Please
ensure the mounting bracket is mounted tightly.
Installation Environment Requirements
•
The installation environment must be free of inflammable or explosive materials.
•
Install the device away from heat source.
•
Do not install the device at a place where the temperature changes extremely.
•
Keep the device away from children.
•
Do not install the device at daily working or living arears, including but not limited to the following areas:
bedroom, lounge, living room, study, toilet, bathroom, theater, and attic.
•
When installing the device at the garage, please keep it away from driveway.
•
Keep the device from water sources such as taps, sewer pipes and sprinklers to prevent water seepage.
•
The product is to be installed in a high traffic area where the fault is likely to be seen.
Note: When installing outdoors, the height of the device from the ground should be considered to prevent
the device from soaking in water. The specific height is determined by the site environment.
