5.
Open the cover of the body.
Take out the cleaved fiber
with care in order not to bring
the harm to the end face of fiber.
6.
For the continuous operation, remove the cleaved
fiber, repeat the step 1~ 5. In this process, be careful
not to get injured by the cutting edge.
◎
Blade Replacement & Blade Position Adjustment
☉
The cutting spots from 1 to 12 are marked on the blade.
☉
When it does not cleaves the fiber normally, clean the rubber pad and the edge of the blade with an-soaked
swap.(But, do not use acetone or solvent when you clean the rubber pad.)
☉
However, if it still does not cleave the fiber properly, it means the cutting spot edge is fully used. So you need
to change the cleaving position. Change the spot and the position according to the following order when you
need.
A.
Blade Adjustment (Cutting spot marked on the blade, 1
～
～
～
～
12)
1.
Release the center setscrews around Cam not much.
2.
Rotate the blade to the anti-clockwise direction. Choose the next spot.
The blade is originally fixed on “position 1”.
Treat the blade with care not to touch the tip of the blade.
B.
Blade Height Adjustment
1. Hold the cleaver body ,
Release the 2 setscrews
around Cam.
2.
Small rotate the setscrew
on the left side as figure shown.
(When clockwise direction, the height up )
when anti-clockwise direction, the height
down )
3.
Put the stripped fiber into the fiber holder and then close the pressing board.
Move the blade back and forth until the blade can be touched
the fiber a little, not much.
If not ok, repeat the step 2, to adjust the blade height.
Cam
When ok, Fasten the 2 setscrews around Cam.
C.
Blade Replacement
1. Release the center setscrews,
Remove the old blade to replace to new
blade.
2. Repeat the Blade Height Adjustment
3. Fasten the 2 setscrews around Cam.
Note:
Please do not fasten the fiber cleaver with screws that are not original by yourself.
User Manual
