68
C
B
G
D
F
E
69
68
Check the Rotational Timing
of the Shuttle Gib Hook
The shuttle gib hook (
B
) is driven by the shuttle
driver (
C
)� To change the rotation of the hook,
the driver must be repositioned�
1�
Turn the balance wheel so the gib
hook point (
D
) is at its farthest position
counterclockwise as shown (
68
)�
2�
Use your finger to push the gib hook
counterclockwise to remove any gap at
E
�
3�
Measure the distance between the gib
hook point (
D
) and the needle (
F
)� The
driver is correctly positioned when the point
is between 1/8 inch and 3/16 inch left of
the needle (
G
)�
If spaced properly, the driver is set
correctly� If not, continue to adjust the
driver (p� 48)�
Hook/Driver Gap
Oscillating hook sewing machines have loose tolerances between the shuttle gib hook and the shuttle driver� This play
between the parts is intentional and allows the Ultrafeed to sew a wide variety of thread sizes� The typical play between
parts is 0�04 inch (
A
)�
A
Adjust the Driver
The driver (
C
) is secured to the lower shaft with two set screws (
H
)� Loosen the screws and gently twist the shuttle driver
to match (
G
). If the fit to the shaft is tight, carefully use a screwdriver as leverage. Do not allow the driver to move to the
left, which would be evident by any play between
J
and
K
� Once proper position is found, retighten the two set screws
(
H
)�
Grab the lower shaft (
I
) and move it left and right� There should be no movement between
J
and
K
� If there is movement
between
J
and
K
then the driver (
C
) has shifted left on the lower shaft (
I
) and must be reset�
After adjusting the driver, check the left-right positioning of the shuttle gib hook (p� 49)�
H
I
J
K
47 |
Sailrite�com
Ultrafeed
®
LSZ Guidebook
| 48
