Sagi KP12G1M, Инструкция по использованию и установке, Страница: 88 / 189

GB
18
Use the up and down keys to scroll the controller parameters
Press the enter key to confirm your selection.
The current value of the parameter selected in flashing mode is
visualised.
Use the keys up and down to select the new value
Press the enter key to confirm your selection.
USER PARAMETER CONFIGURATION - PROBE READING
Push the up and down buttons simultaneously and hold down for more
than 3 seconds.
The label [
Loc ] is visualised.
Utilise the up and down buttons to scroll the sensor probe readings and
the user parameters.
Press the enter key to confirm your selection and enter the mode for
reading probes or changing parameters.
The current value blinks on the display.
Use the keys to select the new value, applicable to parameters
only.
Press the enter key to exit or confirm the selection of the parameter new
value; the setting stops blinking.
DEFAULT PARAMETER RECOVERY
On starting the appliance, a
“LAMPTEST” phase will start.
If you press the enter key 3 times consecutively during this phase, all
default parameters will be reset.
The display shows [
rLd ] indicating the reset of the values pre-set by the
manufacturer.
ALARMS
UNIT WITH BROKEN SENSOR PROBES DURING CONSERVATION
Room probe error
If the room probe is broken or the relevant connection interrupted, the display shows the
label [
E0 ].