Sagi HD70, Руководство оператора, Страница: 79 / 175

5
INSTALLATION
The refrigerators are always send packed and on pallet. (33)
On receiving and after having unpacked in case of dammages or missing pieces act as described in the
chapter "GENERAL NOTES BY THE DELIVERY".
All setting up and starting operations are to be carried out by skilled staff. (30)
Remove the packing box with care so as not to dent the equipment surface. (34)
WARNING : package parts (plastic bags, polystyrene foam, nails and the like) are dangerous for children
and must not be left within their reach.
With a fork truck lift pull up the refrigerator and take it to his place paying attention not to unbalance the load.
(35)
WARNING : never place the refrigerator horizontally during transport; this may cause serious structure
and system damage. (36)
WARNING
: whether for the positioning or for further riplacements do not push or pull the refrigerator, to
avoid to upset it or to damage some parts. (37)
WARNING : do not install the refrigerator near heat sources or in rooms with high temperature, this would
cause a lower efficiency with higher wear of it. (38)
WARNING: Distance from the ceiling should be 50 cm at least. Appliances can be placed next to each
other, but in case of condensation space them out 20 cm at least.
Remove protective film from product.
This may cause unpleasant static electricity discharge which, however, is not dangerous.
The inconvenience is reduced or prevented by continuously holding the refrigerator with one hand or
grounding the package. (39)
After having positionned the machine remove the pallet using a chisel and a hammer, paying attention not to
dammage the feet under the blocks or the refrigerator. (40)
Draw the stiffening block from the port under the machine. (41)
Now it is possible to regulate the feet. (42)
Put the appliance at level by keeping it slightly inclined at its back in order to allow the optimum self-closing
door. (43)
Clean with tepid water and neutral soap (as written in the chapter "CLEANING") and mount the fittings
placed into the refrigerator.
The refrigerator is supplied with an electric plug, SHUKO type. Make sure if complies with EN60320 and
national regulations. Otherwise, replace with a complying one. (44)
WARNING : The operation must be carried out by a skilled technician. (30)
Check that the line voltage corresponds to the one refered on the refrigerator's identification tag. (45)
Then insert the plug into the current tap. (46)
Now the installation has come to end.