17
Restarting and resetting the SE681 WiMAX
SE681 WiMAX / engbt / SE681_FUG_EN_9 / Installation.fm / 18.5.11
Schablo
ne 201
1_04
_07
Switching on the devices
Connect the mains adapter plug to the SE681 WiMAX socket.
Power up the PC.
Connect the mains adapter to the mains power supply.
The system starts up and performs a self-test. After the self-test, the SE681 WiMAX
continually attempts to register with a WiMAX network. Registration may be suc-
cessful immediately. If not, registration will take place when the SE681 WiMAX is
being configured.
Check the LEDs during startup:
LEDs during startup:
– The
Power
power supply LED lights up
green
, and the SE681 WiMAX starts a
self-test. If the LED does not light up, check that the mains adapter is connected
correctly and the power socket is live.
– The
LAN
Ethernet LED is continuously lit
green
. If the LED does not light up,
check that the Ethernet cable is connected correctly.
– If registration with a WiMAX network has already been successful, the
Online
LED lights up
green
. If the LED does not light up, register your SE681 WiMAX
during configuration.
Restarting and resetting the SE681 WiMAX
!
Only use the SE681 WiMAX with the mains adapter supplied.
The reset button is located inside the SE681
WiMAX so that it cannot be pressed accidentally.
If you need to restart or reset the SE681 WiMAX,
use a thin object such as an opened up paper
clip.
