Contact Us
1-844-504-SAGE(7243)
SAGEbyHughes.com/support
Deadbolt Lock
Re-pairing Deadbolt Lock with the SAGE Hub:
1. At SAGE Hub: Go to Settings/Add Devices/Doors;
proceed up to the Pair button, but don’t press it yet.
2. At the lock button pad: Enter Master PIN, then # .
(If lock unlocks when you press a button, try again.)
3. Enter 7 # ; then enter 1 # . The blue LED lights.
4. Return to the SAGE Hub TV interface; press Pair.
Full Reset (requires access to lock’s batteries):
IMPORTANT:
This last-resort procedure erases all PIN
codes and settings! Refer to package instructions.
1. Unscrew and remove the battery compartment
cover. Remove the batteries.
2. Remove the lock interior escutcheon (enclosure).
3. The Reset button is above the PCB cable
connector. Press and hold Reset for at least 3
seconds.
4. Insert the batteries and release the Reset button.
5. Replace interior escutcheon and battery cover.
6. At the SAGE Hub, re-pair the Deadbolt Lock.
Be sure to follow onscreen instructions for PIN setup.
•
For help with installation, see the Deadbolt Lock
installation video. To view it, press Settings on your
SAGE Remote Control, then navigate to Install Videos.
• Never reveal the Master PIN to casual users. Instead,
follow the Yale package insert instructions for creating
user passwords that can be deleted later if necessary.
• The Master PIN can’t be changed. It also can’t be
recovered if you forget it. You must perform a factory
reset of the lock and then re-enter all of your lock codes.
• By default, the Deadbolt Lock is set to lock with a
single press of any button. If desired, you can disable
this; refer to the Yale package insert instructions.
• If the Deadbolt Lock sounds like it is slowing down, the
batteries may need to be replaced. You may also see
alerts that the lock’s batteries are getting low. Be sure to
replace the batteries as soon as possible. You should not
need to redo any settings after changing the batteries.
• To check the pairing and battery status of your
Deadbolt Lock: Using your SAGE Remote Control, press
the Home button twice. Navigate to List Devices, and
then select it. Look for your Deadbolt Lock(s) in the list.
•
You can extend or improve the signal from your SAGE
Deadbolt Lock to the SAGE Hub by using an AC-powered,
plug-in SAGE device, such as a Lamp Dimmer
or an
Appliance Switch. These devices act as signal
repeaters
between SAGE devices (except for the SAGE cameras)
and the SAGE Hub
.
•
You can’t create a SAGE Rule to unlock a Deadbolt
Lock, only to lock it. The one exception: you can create a
Rule to unlock a lock by pressing a SAGE Remote Control
key.
© 2016 EchoStar
1
Tips and tricks:
TROUBLESHOOTING GUIDE
