MorphoAccess® SIGMA Extreme Series - Installation Guide
Annex 1 : Finger Placement Recommendations
Identity & Security
2017_2000024418 - V1
April 2017
This document and the information therein are the property of
Safran Identity & Security
.
They must not be copied or communicated to a third party without the prior written authorization of Safran
29
Before proceeding to the installation
Make sure that you have all the components described in “Components of the initial
package” section at your disposal.
Remove the wall plate. Keep this element at hand.
Figure 6: Removing wall frame
It is then possible to fix the terminal on the wall.
The recommended height for fixing of the terminal is 1.30m (camera height).
For an optimal use the terminal must be installed in an area where the
lighting conditions are controlled. Avoid direct exposure of the sensor to
the sun light and ensure good ambient lighting for face detection if used.
