SDC-650 Multiple door controller
3
Copyright© 2015
– Saflec Systems (Pty) Ltd.
http://www.saflecsystems.co.za
The configuration and diagnostics OLED panel
The configuration panel has been added to simplify some configuration tasks for the installer. It
has an OLED screen and 5 buttons for control. The Left and Right buttons are used to change
pages or move to another field within a configuration page when configuring. The Up and Down
buttons are used on all number fields to increase or decrease the value and the Enter button is
used to apply changes or to activate a command.
Once the controller is given power the panel will be active. If the screen is blank, it will be in
screen-saving mode. Tapping any button will awaken the screen and allow you to configure the
device.
Figure 3
The configuration and diagnostics OLED panel.
Various tasks can be performed from the menu system, however only a few tasks will be covered
in this guide.
NOTE:
Some functions are password protected and the password must be entered before being
given access to that function. The default
password is ‘1234’ – but this can be changed from the
web interface. When the password is requested you would use the Up and Down buttons to
change the letter or number shown until it is correct, then Right to move to the next character. This
process would repeat until the entire password has been entered, then the Enter button is pressed
to confirm.
