Step 1
Remove unit, weights, and arm assembly from skid.
Step 2
Remove upper and lower pins from front of body
front assembly, and set one pin aside. Remove
mast assembly from body front assembly, and
rotate 180 degrees so horizontal arm is facing
away from the body front assembly.
Step 3
Insert the arm assembly into the mast assembly,
aligning the holes in the back of the arm assembly
with the holes in the front of the mast assembly, and
pin in place with two pins.
Step 4
Raise mast assembly until the hole in the bottom of
the mast assembly lines up with the top hole of the
body front assembly, and pin in place using one pin.
Step 5
Remove the two pins on the bottom of the
body front assembly. This will release the body
telescoping central section and the body rear
assembly, allowing these to be slide out from
the body front assembly.
Roof Reach Assembly Instructions
