SafeCom Nuance Mx, Справочное руководство, Страница: 21 / 30

3 AppBlaster
D60829-07 21
3.4 Start AppBlaster
1. Open the folder that you extracted the files into (3.3).
2. Double-click AppBlaster.exe to start AppBlaster
3.5 Configure selective card reading
AppBlaster can be used to enable/disable protcols. This can be used to ensure
that a multiprotocol card returns only one ID code when it is presented to the
Nuance Mx Proximity Reader.
WARNING: It is highly recommended to ALWAYS save the configuration as
project (3.5.1), as it allows you to modify the configuration settings later and
also share the project with Nuance Imaging Customer Support for
troubleshooting when required. It is NOT possible to re-establish the
configuration based on a production image (3.5.2).
Note: Doing an interactive configuration in AppBlaster will result in ALL ID
codes being written in the same output format (default is Hexadecimal).
With the standard SafeCom firmware the HID Prox ID codes are written in
Decimal format, whereas all other are written in Hexadecimal format.
Table 2 Card reader compatibility on page 10 lists the different formats and
there is a note with additional details for the HID Prox ID.