Car lift installation, operation and maintenance manual
Type：4SF-4000C
14
Step 7
：
Install the two drop switch, as shown in the following figure. (optional)
Step 8
：
Install the insurance bar as shown in the following picture.
Note: if the customer requirements: A: control box, B: limit switches, C: two decreased, then the eighth step is necessary after the 5,6,7 step, not in
the 5,6,7 step before, or "two down" wire to install "control box" cannot be installed.
Step 9
：
Installation of the main and the second deck side and dashboard bezel.
Lock the beam in the third lock, and then the main and auxiliary table with a crane on the beam, with the M18*110 six angle screw, spring washer,
flat washer, nut "dashboard bezel",The beam and the main and auxiliary table are as follows
：
1.main column, 2. second column, 3. main board, 4. board, 5. beams, 6. dashboard bezel, 7.M18 nut, 8.M18 cushion, 9.M18 flat pad, 10.M18*110
Connect to control box
Main column
M5*12 cross head screw
Limit switch fixing plate
Limit switch
M5*12 cross head screw
M20 Nut
M20 Flat pad
Roof
Insurance strip
Th
e
saf
ety
blo
ck
is
ins
ert
ed
int
o
the
cro
ssb
ea
m
slid
er
Beam slider
Beam
