background image

XL-AA20023TS-en-US Rev A · 2019-04-04 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF, 
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.

Figure 2

SAF

®

 Tire Pilot Plus

 Pressure Management System 

March, 2019

Troubleshooting Guide

All Trailer Axles

Refer to the link here for a troubleshooting video.

https://vimeo.com/user82815417/review/262250351/e88ebf4fc5

Symptom: 

Warning Light on

 

Problem:

 

System air pressure low between 10-20 PSI of regulator 
setting.

Solution: 

Check for system air leaks. Connect air supply and pressurize 
air tank. Open Tire Pilot Plus air system valve on the regulator 
box as illustrated in 

Figure 1

. If the leak is audible, use soapy 

water to pin point the leak. If the leak is not audible, disconnect 
all tire hoses from the hubcaps as illustrated in 

Figure 2

If after removing tire hoses light stays on, the leak is present 
between the hubcap and the air tank. Check the axle vents, 
hubcap fittings, air tank fittings, pressure protection valve, and 
airline external to the axle for leaking air with soapy water. If 
after removing the tire hoses the light shuts off, the leak is at 
the tire or tire hose. Reconnect each tire hose until the light 
comes back on to pin point the leak. Once the leaking wheel 
is found, use soapy water to discover the source including 
wheel hoses, valve stems, rim to tire, and tire tread. Repair or 
Replace leaking component as necessary or move to the next 
appropriate troubleshooting section below.

Figure 1

VALVE (FOR SYSTEM 
PRESSURE CHECK)

AIR SYSTEM VALVE 
(SHOWN OPEN)

Содержание Tire Pilot Plus

Страница 1: ...ak is audible use soapy water to pin point the leak If the leak is not audible disconnect all tire hoses from the hubcaps as illustrated in Figure 2 If after removing tire hoses light stays on the leak is present between the hubcap and the air tank Check the axle vents hubcap fittings air tank fittings pressure protection valve and airline external to the axle for leaking air with soapy water If a...

Страница 2: ...r a loose connection loosen fitting nut and push tubing further into fitting then retighten nut to 6 10 in lbs or two wrench flats If push to connect type fitting remove by pushing outer ring toward fitting and pull air line free Inspect air line end Recut square and push firmly into fitting until air line bottoms out Symptom Brake air tank de pressurized or low pressure Problem No pressure protec...

Страница 3: ...ings loose or not sealed axle vent fitting loose or not sealed Solution Make sure the hubcap oil plug is pushed into hubcap properly Replace oil plug if damaged Install new hubcap gasket if the gasket is missing or damaged Check for system air leaks per the procedure in warning light on Repair leaks as required Check axle vent fitting and re install as necessary Regulator Setting psi Valve Pressur...

Страница 4: ...LLAND S A SAF HOLLAND GmbH and SAF HOLLAND Inc From fifth wheel rebuild kits to suspension bushing repair kits SAF HOLLAND Original Parts are the same quality components used in the original component assembly SAF HOLLAND Original Parts are tested and designed to provide maximum performance and durability Will fits look alikes or worse yet counterfeit parts will only limit the performance potentia...

Отзывы: