SAF tehnika Integra-W Series, Руководство пользователя

Страница: 52 / 82

INTEGRA-W/INTEGRA-WS User Manual WEB GUI
SAF Tehnika JSC
52
Modify mode
1) IP address – Indicates IP address of Integra-W/Integra-WS you are currently logged
in (status mode); allows specifying IP address of Integra-W/Integra-WS you are
currently logged in (modify mode). Default IP address is 192.168.205.10 or
192.168.205.11 – depending on which side the specific Integra-W/Integra-WS is –
low side has 192.168.205.10 IP address and high side – 192.168.205.11.
Integra-W/Integra-WS IP addresses need to be in the same subnet.
2) IP Mask – Indicates IP mask of Integra-W/Integra-WS you are currently logged in
(status mode); allows specifying IP mask of Integra-W/Integra-WS you are currently
logged in (modify mode). Default IP mask is 255.255.255.0.
3) IP gateway – Indicates gateway address of Integra-W/Integra-WS you are currently
logged in (status mode); allows specifying gateway address of Integra-W/Integra-
WS you are currently logged in (modify mode). By default gateway is not specified
(blank).
4) Ethernet MAC address – shows the MAC address of Integra-W/Integra-WS you are
currently connected to.
5) Remote IP address – shows IP address of remote (far-end) Integra-W/Integra-WS.
By default remote IP address is being retrieved automatically and therefore “Auto”
checkbox is selected. In modify mode you can unselect “auto” option and enter
remote IP address manually.
6) By pressing „Execute configuration” changes made to the corresponding section
apply only for the local side Integra-W/Integra-WS .
CLI commands ( System

Tools

Console )
system ip addr <IP> Use to set IP address of management CPU.
system ip gw <IP> Use to set IP address of gateway.
system ip mask <mask> Use to set subnet mask.
system ip mac Use to show MAC address of management CPU.
system ip cfg <ip address>
<mask> or <ip address>
<mask> <gateway> or <ip
address/CIDR> or <ip
address/CIDR> <gateway>
Use to set IP address and sub or optionally IP address,
subnet mask and gateway simultaneously.
system remoteip show Use to show remote IP address.
system remoteip auto Use to set automatic retrieving of remote IP address.
system remoteip set <IP> Use to define remote IP address.
system diag ping <IP_address> Use to ping an IP address.
System

Configuration

SNMP configuration
The SNMP configuration pages provide configuration of SNMP communities, host and
trap addresses. SAF NMS system will work only when SNMP is properly configured.