SAESHIN Traus ENDO, Инструкция по эксплуатации

Страница: 9 / 20

- Check if the angle handpiece/prophy head connected properly to the motor handpiece.
CONNECTION OF EACH PART
1. Connection of charger
① Connector the power cord to the power cord connection socket on the back of the charger. ( Picture 1)
② Insert the power cord and plug in.
③ Plug the motor handpiece into the charger with it facing forward. ( Picture 2)
2. Connection of angle handpiece/prophy head
Angle handpiece/prophy head can be connected to motor handpiece at any position.
Align angle handpiece/prophy head positioning pins with the positioning slots of motor handpiece and
insert the head until “Click” pull it out axially for removing.
When removing, hold the motor handpiece and pull the angle handpiece/prophy head.
3. Connection and disconnection with file
① Connection : Slide the file inwards by matching the home position until the angle handpiece clicks.
② Disconnection : Press the button on the head to pull out the file.
- Turn off the power when insert or remove the file.
- Pull out the file to confirm locking it after connecting the file.
- Clean the chuck of angle handpiece at all times. The file can lose its balance or chucking power can
be weakened if there is rust inside of the chuck.
① Remove the rubber cap from the product.
② Use a cross screwdriver to loosen the screw in that portion.
③ Open the battery cover to remove the battery. Check the positive and negative poles of the product and install
new batteries properly. Reassemble the battery cover in reverse order.
Prophy head
Angle handpiece
Prophy head
Angle handpiece
( Picture 1) ( Picture 2)
DPA bur Prophy head
① ②
4. Battery change
- Use batteries of the correct rating. (DC 1.2V, 750mAh / 2 pcs)
- When replacing the battery, make sure to check the direction of the + poles and – poles.
Rubber cap Battery cover Screw
① ② ③
7