SAESHIN Traus ENDO, Инструкция по эксплуатации

Страница: 8 / 20

BUTTON ON THE OPERATION PANEL
LCD WINDOW
Power Button
: Push the power button until the power is on and the LCD panel lights.
Push the power button until turn off over the 1 second.
Select-S Button
- The button is to select the setting for gear ratio, torque, auto reverse
Program-P and Memory Button
: Select a program from 1 to 5 and use this button to save the memory.
UP/Down Button
: To set needed rpm, gear ratio, auto reverse by using the Up/Down button.
※ The setting range of rpm and torque are different from gear ratio.
Motor ON/OFF Button
: Push the button, then motor runs and stops.
1. Auto reverse mode display
: Shows the currently selected auto reverse mode. (no display on the screen or )
2. Battery display
: Shows 3 steps for charging amount.
3. Beep display
: Beep sound function each operating condition.
4. Program display
: Shows the program number currently selected. 1~5 are displayed and 5 can be saved.
If you turn the power off and on again, it will always return to the last program you started.
5. RPM display
: The currently set rotational speed is displayed.
6. Gear ratio selection screen
: The currently set gear ratio is displayed. Used to change gear ratio.
7. Torque selection screen
: The currently set torque value is displayed. Used to change torque value. (Unit N.cm)
8. Auto reverse mode selection screen
: The currently set auto reverse mode is displayed. Used to change auto reverse mode.
- Be careful that the LCD on the motor handpiece could be damaged by impacting or dropping.
<LCD>
1 [ Picture 1 ] [ Picture 3 ] [ Picture 2 ]
3
2
4
5
6