SAESHIN Implant XCUBE, Инструкция по эксплуатации

Страница: 43 / 48

Note 1: At 80 MHz and 800 MHz, the higher frequency range applies.
Note 2: These specifications may not be applicable in all situations. Electromagnetic propagation
is affected by absorption and reflection from structures, objects and persons.
(a): The electromagnetic field strength of fixed radiofrequency emitters, such as base stations
for mobile telephones (cellular / cordless), mobile radio, AM/FM radio broadcasts and TV
broadcasts cannot be determined exactly by theory.
To assess the electromagnetic environment due to fixed radiofrequency emitters, an
electromagnetic environment measurement must be made. If the measured radiofrequency field
strength in the immediate environment where the product is used exceeds the compliance level
specified above, the performance of the product must be tested to verify whether it conforms
to the specification. If abnormal performance is observed, additional measures may be necessary,
such as reorienting or relocating the product.
(b): In the 150 kHz to 80 MHz frequency range, the electromagnetic field strengths must be
less than 3V/m.
(3) ELECTROMAGNETIC IMMUNITY / RADIOFREQUENCY MOBILE EQUIPMENT
Maximum length
Micromotor with Motor cord
Foot controller with cord
1.2M
1.2M
1.5M
rms
rms
Portable and mobile RF communications equipmen t should be used
no closer to any part of the including cables , than the
recommended separation distance calculated from the equatio n
applicable to the frequenc y of the transmitter .
Recommended separation distance
d = 1.2 √P
d = 1.2 √P 80MHz to 800MHz
d = 2.3 √P 800MHz to 2.5GHz
Where ‘P’ is the maximum output power rating of the transmitter in watt
(W) according to the transmitter manufacturer, and ‘d’ is the recommended
separation distance (m).
The electromagnetic field strength of fixed radiofrequency emitters, which is
determined by an electromagnetic environment measurement (a), must be
less than the compliance level in each frequency range (b).
Interference may occur near equipment marked with the symbol below:
X-CUBE
40
Conducted RF
IEC 61000-4-6
EN 61000-4-6
Radiated RF
IEC 61000-4-3
EN 61000-4-3
: IEC 61000-3-3 / EN 61000-3-3
: IEC 61000-4-8 / EN 61000-4-8