SAESHIN E-CUBE PLUS, Инструкция по эксплуатации

Страница: 6 / 28

4
< Endo Mode >
< Program Memory Function >
- 7 programmable memories for setting gear ratio, torque, speed, rotating direction and etc.
- Programs 8 and 9 can be used by setting the rotation ratio of the forward and reverse directions in the
reciprocating mode.
< Auto Reverse Function >
- During the procedure, when the actual load is close to the set torque value, an alarm sound is generated
to notify you.
- When it exceeds the set torque value, it automatically stops or reverses.
< Automatic Power OFF Function >
- Power is off with beep sound after 10 minutes without operation.
(During the motor operation even without use, power is not off automatically.)
<AUTO START/STOP>
- When the apex measurement starts, the motor starts to rotate automatically, and when the measurement
is finished, the motor stops. (Available only in APEX+ENDO mode)
<AUTO SLOW DOWN>
- The rotational speed of the motor is gradually reduced according to the ratio of the apex depth, and the
motor stops when it reaches the set APICAL LINE. (Available only in APEX+ENDO mode)
PRODUCT FEATURES
- Max. RPM :
- Max. Torque :
- Apex length measurements : 0.0~2.0 (When contact, O.A(Over Apex) displayed)
- The free-running speed of the handpiece shall be in accordance with the manufacturer’s instructions
at a tolerance of ±10 % as specified. (Refer to ISO 14457)
1:1
10,000 RPM
4:1
3,250 RPM
10:1
1,300 RPM
16:1
800 RPM
20:1
650 RPM
1:1
-.- N·cm
4:1
1.3 N·cm
10:1
3.2 N·cm
16:1
5.2 N·cm
20:1
6.5 N·cm
- The AUTO START/STOP function and the AUTO SLOW DOWN function can be used individually
or at the same time.