3
Put a coffee oil remover tablet in the pre-ground coffee compartment.
4
Press the CAFFÈ CREMA button. The machine dispenses water from the
coffee dispensing spout.
5
When the progress bar has reached the middle, set the main switch on
the back of the machine to OFF.
6
Let the degreasing solution work for approximately 15 minutes.
7
Set the main switch to ON. Press the standby button.
8
Wait until the machine performs an automatic rinsing cycle.
9
Perform the 'Weekly cleaning of the brew group' procedure.
10
Remove the drip tray with the coffee grounds container. Empty the drip
tray and the coffee grounds container and place them back in the
machine.
11
Press the AROMA STRENGTH button and select GROUND COFFEE..
12
Press the CAFFÈ CREMA button. The machine dispenses water from the
coffee dispensing spout.
13
Repeat steps 12 and 13 twice. Discard the dispensed water.
Reinserting the brew group
1
Before you slide the brew group back into the machine, make sure the
two yellow reference signs on the side match. If they do not match,
perform the following step:
-
Make sure the lever is in contact with the base of the brew group.
2
Make sure that the yellow locking hook of the brew group is in the correct
position.
-
To position the hook correctly, push it upwards until it is in uppermost
position.
17
English
