SAD DL08128, Быстрый старт

Страница: 4 / 8

4. Preparing the appliance for use
5. Operation
Setup :
• Remove the appliance from the packaging.
• Place the appliance on a solid surface, such as a table, and adjust the folding tripod.
• It is recommended that you keep your face 15 - 35 cm away from the light during use.
Fastening of SAD Daylight on the wall:
There is a mounting hole on the back side of the appliance. At this mounting hole the appliance can be fixed on
the wall with screw. Depending on the type of wall, an appropriate screw must be used.
NOTE:
• Ensure that there is a socket near the place where the appliance will stand.
• Lay the mains cable in such a way that no one can trip over it.
IMPORTANT: If the mounting hole or back housing is cracked or damaged. Do not fix the appliance on the wall.
Please contact customer service or the dealer for assistance.
1. Switching on the appliance:
Press the ON/OFF button of the appliance to switch on the light.
NOTE: The brightness of the tube may be visibly different when switched on. The tube develops it full luminosity
after a couple of minutes.
2. Safety and performance standards
3. Unpacking and Inspecting
This appliance has been designed and manufactured to conform to the highest standards of safety and
performance including electromagnetic compatibility (EMC). This appliance conforms to the applicable
requirements of the following of Medical Device Directive 93/42/EEC for medical appliances.
Every attempt is made to ensure your order is accurate and complete. However, to be sure that your order is
correct, verify the contents of the box against your packing slip.
The appliance is designed for simplicity of operation and set-up and requires minimal assembly.
The following items are included your box:
1 x SAD Daylight
1 x Operator’s Manual
Carefully inspect each item as it is unpacked for any signs of damage which may have occurred during shipment.
• Check the components according to the packing list.
• Check for any damage or defects. Do not attempt to setup the appliance if anything is damaged or defective.
Contact your supplier immediately if anything is found to be damaged or defective.