Sacmi CCM001, Руководство пользователя

Страница: 77 / 164

002AZ001A
6 - 5
OPERATING INSTRUCTIONS
6
6.3 AUTOMATIC CYCLE
Turn selector 19-23 to AUT to set the machine for automatic operation.
RUNNING THE MACHINE
Press key 1 on the control keyboard to run the machine in automatic mode. This will take place only if all the safety and
work conditions are met.
Messages that indicate faults which prevent the machine from operating will be shown on the keyboard display (see
Instructions B manual).
The sequence of operations carried out by the machine during an automatic cycle are shown in the flow chart below:
1 Cycle start key is pressed
2 Start of plasticization
Start of rotation
Actuators start
3 Drum speeds up to reach required speed
Insertion drum entry
4 Start of pellet ejection
5 Pellets inserted
Start of product rejection
6 End of product rejection
Start of production
STOPPING THE MACHINE
To stop the automatic cycle, press key 5 on the control keyboard. The sequence of operations carried out by the machine
during an automatic cycle are shown in the flow chart below:
1 Stop cycle key is pressed
2 End of pellet insertion
Extruder stops
3 Insertion drum exit
Actuators move down
Rotation stops