SABINE TRUE MOBILITY WIRELESS SYSTEM SWM3000, Руководство по эксплуатации

Страница: 13 / 40

13
B1-SWM-Op-Guide-v4.pmd 030108-hto
Section Five: Receiver & Transmitter Setup
5.2.4 Beltpack Headset/Lavalier Microphone connection
Plug the Headset or Lavalier connector into the 4-pin threaded connector located on top of the UHF of
VHF beltpack transmitter. Be careful to align the notch on the inside of the cord connector with the slot on
the inside of the beltpack connector.
RF Signal LEDs Audio Input LEDs
Figure 5g - Receiver Controls & LEDs
Power On
Indicator light
Figure 5h - Receiver Back Panel Squelch Control
Squelch
MIC LEVEL
ONLY
NOTE: See Section 11.2 Beltpack Transmitter
Connector Wiring Diagrams for Sabine True Mo-
bility connector wiring information.
5.3 Transmitter & Receiver Operating Procedures
5.3.1. Start-up Procedures
1. Power up the True Mobility receiver. The red LED on the power switch will indicate power is on.
2. Check RF Signal indicator
LEDs. Other signal sources,
including other wireless com-
munication devices and trans-
mitters, can interfere with the
operation of your receiver. Be-
fore turning on your micro-
phone or beltpack transmitter,
check to see if any of the RF
Signal LEDs on the receiver
are lit. The number of LEDs that light up will indicate the strength of the interference.
NOTE: Some interference can be dealt with using Sabine’s two-stage squelch. Adjust the Squelch
control knob (“SQ” on rear panel of unit) clockwise until all RF Signal LEDs go out.
CAUTION: Increasing the squelch threshold will
shorten the operating distance possible between
microphone and receiver. A much better solution
is to use the Group and Channel selectors to lo-
cate a frequency without interference or with mini-
mal interference.
3. Power up your mixer and or amplifier. Turn volume
controls to the minimum setting.
Power
Switch
L o w
Battery
Indicator
Mini XLR
Connector
Slot
2. While gently push-
ing to connect, ro-
tate entire connector
until notches & slots
align, and connector
slides into place.
1. Hold cord-side of the connector
here with index finger and thumb,
and place on top of beltpack recep-
tacles.
3. Lock in place with
screw-on sleeve.
Tighten finger-tight.
Screw-on Sleeve
Figure 5f - Connector Placement