K-DOWN
24
Features of the control box
15.
Active RJ-45 Socket:
Your Premium control box is equipped with the active RJ-45 socket,
which allows to plug in additional accessories supplied by SABAJGROUP.
NOTE:
Only the original SABAJGROUP accessories will work with your control box. If you attempt
to modify or connect any other devices via the RJ-45 port, you might damage the control box and
you will loose the warranty for doing so.
Lift operating – control
Every control box with RF function is delivered with a pre-progammed RF Remote. Only Sabaj RF
remotes can operate with Sabaj control boxes. The buttons on the RF remote control are pre-
programmed and cannot be changed.
The control box has 2 levels of setup.
SETUP mode
is acquired by pressing & holding the
SETUP button
, and is signalized by a
RED
SETUP LED light
.
Motion MEMORY mode
is acquired by pressing
the
RC-SET button
. You will hear short beeping
sound.
NOTE:
The lift can be operated by more than one RF remote control. The preferred ranges of
motion will be the same for all remotes.
16.
Programming a new RF remote (optional):
The control box can store up to 8 different RF
remotes. To program a new RF remote:
a. Press the
RC-SET button
. You will see this symbol on the digital display
b. Press & hold for about 2 seconds any button on the RF remote. Properly
programmed remote will result with the digital display symbol disappearing, and a
short beep.
17.
IR-Multicode - IR Remote Setup (optional - requires the purchase of an IR-EYE
accessory):
The IR-Multicode system allows you to use any infrared remote control of the
most popular TV screen manufacturers operating in RC-5 system. You can program the
remote control with which you control your TV. Some newer remotes work on a Wi-
Fi/Bluetooth and, although they might look like a standard remote, they use a completely
different wavelength
– not using the IR receiver. Please be advised, that
you will need the
IR-EYE Sabaj Accessory connected to the controller via the RJ-45 socket to operate
your lift with an IR remote
. To start acquiring the IR remote:
a.
Press & hold
SETUP button
for about 2 seconds
–
red SETUP led
will be lit.
fig. 14
up
down
