Assembly and operating manual
rtv.sabaj.pl/en/home/
Device operating
The control box supplied with the set is pre-programmed for the maximum ranges of the lift
movement.
19. Control panel
20.
Connecting the controller:
connect cable from the lift with the control box.
Then plug in
the main socket. The power supply is signaled by lighting the indicator
POWER
(green).
Then the controller carries out the procedure "self-test" indicating this by three sound
signals and flashing lights "SETUP" (red). After finish this operation the control box is ready
to work. Pressing any button is confirmed by a short beep sound.
NOTE:
Rotating motion is possible only after achieving by Lift programmed preferred TV position
height. Within the lift moving parts can not be any obstacles.
Features of the control box
21.
Active RJ-45 Socket:
Your Premium control box is equipped with the active RJ-45 socket,
which allows to plug in additional accessories supplied by SABAJGROUP.
NOTE:
Only the original SABAJGROUP accessories will work with your control box. If you attempt to
modify or connect any other devices via the RJ-45 port, you might damage the control box and you will
loose the warranty for doing so.
22.
Safety system operation:
The intelligent safety system detects the obstacles when the screen
is moving down as a weight difference. It does not require any calibration, which is done
automatically. After detecting an obstacle the lift stops and moves up a few centimeters. The
safety system works only during the down movement. When the safety system is activated, the
blinking symbol
appears on the display and you will hear a continuous "beep" signal.
fig. 18
