R5
SUPREME Secure W-AIS System
CONFIGURATION
7000 118-524, C1
Page 36
The configured latitude and longitude will be used as start position and the R5
SUPREME transponder will then use the configured values for COG and SOG to
calculate new latitude and longitude for each bogus position report. The reported
heading will have the same value as COG (but truncated) and the reported ROT will
always be zero when using internally calculated bogus position.
If the button “Get True Position” is pressed, the start value parameters will
automatically be filled in with the current true position.
If the button “Get Bogus
Position” is pressed, the start values will be filled in with the current reported bogus
position. It is then possible to make changes to the start values before they are saved
in the R5 SUPREME transponder by pressing “Save”.
NOTE: The start values will not be stored in non-volatile memory. If the R5
SUPREME W-AIS is rebooted while using internally generated bogus position,
the transponder will set the position to invalid in the transmitted bogus reports.
3.10 Target List and Plot
When the operational mode is set to anything other
than “Normal”, the R5 SUPREME W-
AIS Transponder can receive encrypted messages on the encrypted link (Secure, BFT or
STEDS).
Targets received on the encrypted link will be marked as “Secure Targets” with a
green colour in target list and plot while normal Class A targets are marked with orange
colour in target list and white colour in plot.
Figure 25
– Target List, Secure Target marked with green colour
Figure 26
– Plot, Secure Target marked with green colour
