S3 0312FC, Руководство оператора, Страница: 9 / 58

Page | 6

Fan can “free wheel” under any air
movement even with power off and
disconnected. Ensure the rotor is locked
from freewheeling prior to servicing the fan.

Use only tools, jacks and hoists of sufficient
capacity for the job.

Make sure all the guards and shields are in
place and properly secured when the
maintenance work is completed.

Keep body, hair and clothing away from all
moving and/or rotating parts.

Do not allow children, spectators, or
bystanders within the work area.

Use only genuine S3 AIR SYSTEMS
replacement parts or equivalent.
Replacement parts must meet ASABE
standards. Use of unauthorized parts will
void warranty. If in doubt, contact your S3
AIR SYSTEMS dealer.

Remove rotor locking device and replace all
guards before re-starting the fan.
4.9
Safety Decals
S3 AIR SYSTEMS reserves the right to update safety
decals on new fans without notice to owners of
older fans. Safety decals may not be exactly as
shown.
4.10
Decal Installation

Be sure that the installation area is clean and
dry.

Determine the exact position before you
remove the backing paper.

Place the decal over the specified area and
carefully press a small portion with the
exposed sticky backing in place.

Slowly peel back the remaining paper and
carefully smooth the remaining portion of
the decal in place.

Small air pockets can be pierced with a pin
and smoothed out using the decal backing
paper.
4.11
Decal Maintenance

Keep the safety decals clean and legible at all
times.

Replace any safety decals and signs that are
missing or have become illegible.
4.12
Decal Replacement

Ensure the new equipment components
installed during any repair include the
current safety decals specified by the
component manufacturer to be affixed to
the replaced components.

Replacements for damaged or missing safety
decals are available from your authorized
dealer or S3 AIR SYSTEMS.

The complete decal sheet can be found on
the following page. The numbers beside each
decal coincide with the descriptions in the
Decal Locations section.
4.13
Decal Locations
The types of decals and location on the equipment
are shown on the following page. A good safety
practice requires that you familiarize yourself with
the various safety decals, the type of warning and
the area, or particular function related to that area,
that requires your SAFETY AWARENESS.
Note: If Safety Decals have been damaged,
removed, become illegible or parts are replaced
without decals, new decals must be applied.
Note: Decal No. 1 will either read 230 VOLTS, 460
VOLTS or 600 VOLTS, depending on the voltage
rating of your fan.