5
INSTALLED SLIDES’ STRUCTURAL & INSTALLATION CHECKLIST
After installation and prior to the first use of the Rogue
TM
Grand Rapids
TM
and
periodically (see DAILY/WEEKLY MAINTENANCE OF THE ROGUE
TM
GRAND
RAPIDS
TM
) thereafter the owner must:
1. Inspect the runway for visible cracks or tears.
2. Inspect the slide for sharp edges, protrusions, cracks or tears.
3. Inspect all attachment flanges for loose or corroded fasteners.
4. Inspect all ladder tread or step-attachment points for evidence of shear, bending
yield, or fatigue in the ladder steps, rails, or attachments means. Yield is
evidenced by crystallization or fine cracking of the ladder tread and/or surface.
5. Inspect the ladder handrails for rigidity and attachment. (Can they be pulled out
of their sockets?)
6. Measure the following dimensions and compare with the Manufacturer’s
Placement Instructions on pages 3 and 4.
•
Measure the depth of water in front of the slide exit. (4-1/2’ min. depth 4-
1/2’ from exit end of slide.)
•
Measure the height of the slide runway exit above the water. (20” max.)
•
Measure the distance between the slide centerline and the edge of other
pool equipment.
7. Observe the position of the exit of the slide as shown in FIGURES J, K and L on
pages 3 and 4.
INTENDED USE INSTRUCTIONS
* * IMPORTANT * *
READ AND FOLLOW THE SIMPLE SAFETY RULES BELOW.
MAKE SURE THAT EVERYONE WHO USES THE ROGUE
TM
GRAND RAPIDS
TM
KNOWS AND FOLLOWS THESE RULES.
ENFORCE THESE RULES WITH ADULT SUPERVISION
Installed and used properly, the Rogue
TM
Grand Rapids
TM
will give you, your family,
friends and guests many hours of enjoyment. Like any other piece of equipment
however, the Rogue
TM
Grand Rapids
TM
can be misused in such a way as to cause the
user injury, even serious and crippling injury. As the owner of a Rogue
TM
Grand
Rapids
TM
it is your responsibility to do the following:
1. Only one person allowed on the slide at any given time.
2. Roughhousing or horseplay on the slide is strictly forbidden.
3. Do not use the slide as a diving platform. The slide is made for sliding only, not
diving.
4. Before sliding, always be sure that the water lubrication is turned on.
