S.R.Smith ROGUE GRAND RAPIDS, Инструкция по сборке и установке

Страница: 17 / 20

17
27)
After connecting the water hose to ladder water connection, turn on water slowly to
check for leaks.
28) Secure the slide, so that it will not move during the concrete pour, to ensure that the
settings remain the same.
29)
SUGGESTION: To ensure easy removal of concrete from legs and ladder, wax or
wrap with wax paper approximately 12 inches above deck level.
30)
Proceed with pouring the concrete deck and finish as desired. Let concrete cure 24
hours before using slide.
ASSEMBLY INSTRUCTIONS FOR FLUSH DECK MOUNTING
The following instructions are for mounting a slide on an existing deck.
1) Follow the steps listed on the previous page for in-deck mounting, as they are the
same with the exception of the attachment of the deck anchor flanges. NOTE: Rebar
will not be used.
2) Place a deck anchor flange over each end of the slide legs.
3) Using the four holes on each flange as a template (see Figure 25 below), drill four
5/16” holes per flange 1-3/8” deep. CAUTION: Do not drill holes larger than 5/16”.
Maintain drill hole straight and perpendicular for proper holding strength of anchor
stud.
4) Raise the flange up the leg and secure in place while using a hammer to drive the
(#28) 5/16”-18UNC x 2-1/4” Anchor Stud, with a (#28) 5/16” Hex Nut on top, into the
hole leaving 7/8 of an inch of the stud above the deck. Then tighten the nut until it is
flush with the deck. Then, tighten the nut approximately three turns to set the anchor
stud. Finally, remove the nuts.
5) Secure the four flanges with (#28)
5/16” Flat Washers, (#31) 5/16" Lock
Washers and the (#28) 5/16"–18UNC
Hex Nuts.
6) Using the two holes on each ladder
feet as templates, drill holes 5/16"
diameter by 1-3/4 inches deep and
secure (#28) Anchor Studs as
described in 3 & 4 above.
7) Secure the two ladder feet with (#28)
5/16” Flat Washers, (#31) lock
washers, and the (#28) hex nuts. Be
sure that the ladder maintains 15
degrees from vertical.
Figure 25