S-COM 7K, Руководство пользователя, Страница: 209 / 400

Links
13-3
Select Audio Routing Priority
Selects the priority of audio routed to the transmitters or phone line.
•
For routing to transmitters, audio is only routed when the receiver-to-
transmitter path is enabled ( see previous page).
•
In the table, below, AP is the Autopatch/Reverse Patch. Audio is only
routed when the receiver-to-autopatch path is enabled ( see previous page )
and an autopatch is in progress.
•
In the table, below, LL is the landline operating in Phone Line Control Mode .
Audio is only routed when the receiver-to-landline monitor path is enabled
(
see page 7-45 ) and phone line control mode is in progress.
•
Enter the command to select the audio routing priority to modify; replace
each ‘x’ with one digit, 1 through 3, representing receivers 1 through 3, in
the order of priority from highest to lowest
. All 3 receivers must be
specified.
Command Form:
Command Form Data Digit
Select Rx-to-Tx1 Audio Routing Priority (PW) 90 00 x x x * 1 = Rx1, 2 = Rx2,
3 = Rx3
Select Rx-to-Tx2 Audio Routing Priority (PW) 90 01 x x x * 1 = Rx1, 2 = Rx2,
3 = Rx3
Select Rx-to-AP Audio Routing Priority (PW) 90 02 x x x * 1 = Rx1, 2 = Rx2,
3 = Rx3
Select Rx-to-LL Audio Routing Priority (PW) 90 03 x x x * 1 = Rx1, 2 = Rx2,
3 = Rx3
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: Audio Routing Priority is Receiver 1, Receiver 2, then
Receiver 3.
Example:
To specify a priority of Receiver 2, Receiver 1, then Receiver 3 to
Transmitter 1, enter:
(PW) 90 00 2 1 3 *