S-COM 7K, Руководство пользователя, Страница: 110 / 400

7K • Chapter 7
7-16
Select Autopatch Access- and Dump-Triggered Macro
Assigns macros to be executed upon accessing or dumping the
autopatch.
•
Enter the 4 digit macro name, using leading zeroes if the macro name is
less than 4 digits.
•
To delete the assignment, enter the command with no macro name
specified.
•
Also see the Select Autopatch Receiver-Specific Access-Triggered Macros
on page 7-67.
Command Form:
Command Form
Select Autopatch Access-Triggered Macro (PW) 26 12 (macro name) *
Select Autopatch Dump-Triggered Macro (PW) 26 13 (macro name) *
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: No Macros Exist
Note: The Autopatch Dump-Triggered Macro will be executed if the autopatch
“times out.” If a series of calls are made without dumping the autopatch
between calls, the autopatch dump-triggered macro will be executed at the end
of the last call.
Examples:
These commands make the autopatch much more flexible. For example, a
tape recorder can be turned ON and OFF by connecting it to a logic output. It
could then be either activated or de-activated by the autopatch access-
triggered and dump-triggered macros. The tape recorder can be located at a
remote site connected to a CTCSS decoder and receiver on the repeater’s
output frequency. The autopatch access-triggered and dump-triggered macros
can turn the controller’s CTCSS Encoder ON and OFF—and change its
frequency.