Ryobi RLT-710, Руководство по эксплуатации для владельца, Страница: 13 / 16

operAtion
Line FeedinG (Fig. 27)
During use, the tip of the trimming line will get shorter due to wear.
Regularly check the condition of the trimming line (21) and adjust if necessary.
1. Each time the trimmer reaches a certain speed the line will extend by 12 mm.
2. Excess line will be cut by the knife (23) and should always remain inside the radius of the safety guard.
note: the trimming line will wear faster and require more feeding if the cutting or edging is
done along sidewalks or other abrasive surfaces or heavier weeds are being cut.
repLAcinG Line spooL
Replace the line spool when it is empty or worn.
1. Turn the product over to access the trimming line.
2. Hold the trimmer head steady with one hand and with the other hand release the cutting head cover (17) by
pressing the release latch (18) on both sides.
3. Lift the cover from the trimmer head (Fig. 28).
4. Remove the spool (20) from the housing and discard all line on the spool (Fig. 29).
5. Clean the housing before inserting a new spool of the same type.
6. Lead the line ending through the eyelets of the housing.
7. Replace the cutting head cover; make sure it snaps in place.
Fig. 29
20
Fig. 28
18
17
Fig. 27
23
Line Feed
21
12