ENGLISH
6
1. Trigger handle
2. Trigger
3. Lock button
4. Cord retainer
5. Motor housing
6. Front handle
7. LiveTool Indicator
8. Upper shaft
9. Lower shaft
10.Shoulder strap
11.Safety guard
12.Cutting line
13.Wing nut
14.Coupler
15.Knob nut
16.Bolt
17.Washer
18.Screws
19.Bracket
20.Clip
21.Loop
22.Bump knob
23.Cut off blade
24.Spool
25.Trimmer head
26.Drive shaft
27.Spring
SPECIFICATIONS
DESCRIPTION
Voltage................................................... 230-240V~50Hz
Nameplate Power ................................................. 1000W
No Load Speed.................................................7,000/min
Cutting Line ...........................................................1.5mm
Max.Cutting Path. ................................................380 mm
Measured Sound Power Level ................. L
WA
: 90.9dB(A)
Sound Pressure Level ........ L
PA
:79.2dB(A); K
PA
: 3.0dB(A)
Vibration ...........................................4.8m/s
2
, K=1,5m/s
2
Weight ....................................................................4.8 kg
ASSEMBLY
CONNECTING LOWER SHAFT TO THE UPPER
SHAFT
(FIG.2)
WARNING:
The split shaft is for transport and storage purposes
only. The electric power head is not recommended for
use with any other attachment.
The coupler (item 14) connects the lower shaft to the upper
shaft. Follow these steps to connect the lower shaft to the
upper shaft.
n
Loosen the wing nut (item13) by turning it
counterclockwise.
n
Remove any end cap from the lower shaft.
n
Align the button with the guide recess on the upper shaft.
n
Slide the lower shaft (item9) into the upper shaft (item8)
until the two shafts click into place.
NOTE:
If the button does not release completely in the
positioning hole, the shafts are not locked. Slightly rotate
the lower shaft until the button is locked into place.
n
Tighten the wing nut (item13) securely by turning it
clockwise.
NOTE:
During operation, periodically check the wing nut
(item13) and tighten as necessary.
REMOVING THE LOWER SHAFT FROM THE
UPPER SHAFT
(FIG.2)
Disconnect the upper shaft and lower shaft for storage or
when transporting.
Follow these steps to remove the lower shaft from the
upper shaft.
n
Release the trigger (item 2) and allow the trimmer to
coast to a stop.
n
Unplug the trimmer.
n
Loosen the wing nut (item 13) by turning it
counterclockwise.
n
Push the button, while pulling the two shafts apart.
ATTACHING THE FRONT HANDLE
(FIG.3)
Follow these steps to attach the front handle.
n
Press the front handle (item 6) onto the upper shaft (item
8) so that the handle is angled back toward the trigger
handle (item 1).
n
Place the front handle along the upper shaft to a position
that allows for comfortable operation.
n
Slide the bolt (item 16) through the holes in the front
handle.
n
Slide the washer (item 17) onto the bolt.
