Ryobi P3650, Руководство оператора

Страница: 24 / 100

24 − English
OPERATION

When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table.
See Figure 34.

Align cutting line on the workpiece with the edge of saw
blade or laser line.

Grasp the stock firmly with one hand and secure it against
the fence. Use the work clamp, C-clamp, or other suitable
clamp to secure the workpiece when possible.
 Before turning on the saw, perform a dry run of the cutting
operation just to make sure that no problems will occur
when the cut is made.

Grasp the saw handle firmly then squeeze the switch
trigger. Allow several seconds for the blade to reach
maximum speed.

Slowly lower the blade into and through the workpiece.

Release the switch trigger and wait until the electric brake
stops the blade from turning before raising the blade out
of workpiece and removing the workpiece from the miter
table.
TO SLIDE CUT
See Figures 32 - 33.
WARNING:
Never make a cut by pulling the saw toward you as the
blade can climb on top of the workpiece and come toward
you. Failure to heed this warning could result in serious
personal injury.
The sliding feature will cut workpieces 12 in. wide by
1-1/2 in. thick or 3-1/2 in. wide by 3-1/2 in. thick. With the
saw off, pull the saw arm forward. Turn the saw on (let blade
reach maximum speed), push the blade down cutting into the
workpiece then back toward the rear of the saw to make a
cut. Cuts are made by pushing the saw blade away from you
and toward the bevel scale at the back of the saw stopping
when the full rear position has been reached after each cut.
When the saw is running (turned on),
NEVER pull the saw
blade toward you or toward the front of the saw.

Raise saw arm to its full height.

Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board is placed against the fence, the board could
collapse on the blade at the end of the cut, jamming the
blade.
See Figures 39 - 40.

When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table.
See Figure 34.

Align the cutting line on the workpiece with the edge of
saw blade or laser line.
 Loosen the slide lock knob by turning the knob counter-
clockwise.
SLIDE CUT
SLIDE SAW ARM
FORWARD THEN
PUSH DOWN
Fig. 32
SLIDE LOCK
KNOB
PUSH
BACK
Fig. 33
SLIDE CUT

Grasp the stock firmly with one hand and secure it against
the fence. Use the work clamp, C-clamp, or other suitable
clamp to secure the workpiece when possible.
 Before turning on the saw, perform a dry run of the cut-
ting operation to make sure that no problems will occur
when the cut is made.

With the saw off, grasp the saw handle firmly then pull
the saw forward until the saw is fully extended.
 Squeeze the switch trigger. Allow several seconds for the
blade to reach maximum speed.

Slowly lower the blade into and through the front edge
of the workpiece.