Ruris Clean PowerJet 1100, Руководство пользователя

Страница: 76 / 132

EN
12
3. Check that there are no water leaks at the joints. If there is water leakage, please
reconnect the water hose, spray gun or spear to make sure each accessory is perfectly
connected.
4. Connect to a 220V / 50Hz ground power supply.
5. Set the power switch to position "I". (Fig.5)
6. Operate the shutter and turn on the washer.
WARNING! Fig.5
Check that the supply voltage and frequency correspond to those specified on the
appliance's technical plate. The appliance should only be connected to a power supply
via a security switch (Max.30mA) to turn off the power supply in the event of a short
circuit.
6.1 OPERATION
1. Safety valve it is also a pressure relief valve. When the gun shutter is released, the
valve opens, the presostat acts and the machine stops automatically.
If the nozzle of the gun is blocked, which will cause the pressure to increase, the safety
valve will open and the car will stop automatically. See point (7) to see how the nozzle
can be cleaned.
2. Gun safety button
Press the release button and then operate the shutter to perform the spray operation.
When you release the shutter, it can automatically return to the off position.