Ruris AquaPower 1008S, Руководство пользователя

Страница: 87 / 155

EN
11
Check that the voltage and frequency of the hydrophore in the stamp plate corresponds
to that on the electricity supply network.
The installer must ensure that the electrical system is grounded in accordance with the
regulations in force.
Make sure the electrical system has a high sensitivity circuit breaker = 30 mA (DIN VDE
0100T739)
Protection to overload
RURIS hydrophores have a built-in thermal protection switch. Hydrophore stops if an
overload occurs. The engine restarts automatically after it has cooled. (see section 3 of
the Defects and remedial actions chapter).
The power cord must have a minimum section equivalent to that of the H07 RN-F cable.
The track and connections must be protected from water jets.
6. COMMISSIONING
Before commissioning, fill the suction pipe (2) and the body of the hydrophore (8) using
the filling valve (9). Turn off the tap after checking that there are no leaks. Open the
closing devices on the discharge pipe (eg water tap) so that air can be released from the
suction circuit. Position the switch on the cover of the "I" switch and insert the hydrophore
plug into an AC outlet. Hydrophore starts immediately. If the hydrophore is not used for
a long time, it is necessary to repeat all the operations described above before starting
the hydrophore.
Pressure switch adjustment
The hydrophore pressure is preset by the manufacturer at 1.4 bar for starting pressure
and at 2.8 bar for the pressure needed to stop the hydrophore.To change these settings,
contact a qualified electrician.