Ruris AquaPower 1008S, Руководство пользователя

Страница: 80 / 155

EN
4
2. SAFETY INSTRUCTIONS
Read this manual carefully before installing the hydrophore.
Keep this manual carefully. If problems arise, contact the RURIS authorized service.
Please check that the hydrophore has been used correctly and that the problem is caused
by its operation.
Hydrophores can be used for residential applications to pump clean water at constant
pressure; to provide water for toilets, washing machines, dishwashers and to spray the
garden. They can also be used for pressurized systems to increase hydrostatic pressure.
These hydrophores are also suitable for distributing drinking water.
Hydrophor cannot be used for salt water, flammable substances, corrosives or dangerous
liquids. Check that the hydrophore never works without liquids.
Do not point the water jet directly at the machine or other electrical components!
* Do not touch the plug with your wet hand! Unplug the machine, holding the plug, not
the power cord. * Connect only to a grounded outlet, mounted correctly and checked.
The voltage and safety of the circuit must correspond to the specified values.
Protection will be provided by a residual current device (RCD) of max. 30 mA. The
grounded socket or the plug of an extension cord must be placed in areas protected
from contact with water. Use only extension cables with the appropriate cross section
of the conductors. Unwind the cable rollers completely. * Do not bend, crush, pull or
drive over cables and extenders; protect against sharp edges. * Place the extension
cord so that it does not penetrate the pumped liquid. * Unplug the machine before any
service operation.
Before use, check the power cord. Make sure it is intact.
If the cable is damaged during use, disconnect the power immediately.
DO NOT TOUCH THE CABLE BEFORE DISCONNECTING THE MACHINE!