Rupes HQM83, Инструкция по эксплуатации

Страница: 9 / 32

9
Speed control
The speed of your tool can be changed by rotating the speed regulation knob (2) to the desired setting. The speed
regulation knob (2) can be set for any speed between 2000 and 5000 RPM.
Batteries and motor protection
The electronic protection protects the motor and batteries from overheating. Also it guarantee a longer life of both.
NOTICE: in a case of overcurrent caused by repeated starts or excessive overloads, the protection in the
current turns off the tool and the RED blinking light will be shown in a battery pack level indication.
Battery pack level indication
The battery level LED show the charge level of the batteries changing the colour:
GREEN: from 100% to 50% batteries charge
YELLOW: from 50% to 20% batteries charge
RED: from 20% to 0% batteries charge
RED BLINKING: 0% battery charge: the tool does not start.
STARTING UP
Before starting-up the tool ensure that:
- the packaging is complete and does not show signs of having been damaged during storage or transport;
- the tool is complete; check that the number and type of components complies with that reported in this instruction
booklet.
ACCESSORIES ASSEMBLY
WARNING: Before (dis)assembling the tool assure that the speed regulation Knob (2) is in OFF
position
BACKING PAD MAGNETIC ATTACHMENT
CAUTION: Accessories must be rated for at least the speed recommended on the tool-warning
label. Accessories running over rated speed can fl y apart and cause injury. Accessory ratings must
always be above tool speed as shown on tool nameplate.
WARNING: Backing pads must be removed pulling on his axis, as shown in Fig. 5. For your safety,
if you try to bend the backing pad to remove it, it will not come off (Fig. 6).
Ensure that the hexagon (11) (Fig. 4) is in a correct position to match the backing pad hexagonal recess. If the
round backing pad (13) is attached, the power tool movement is random orbital. If the swallow backing pad (4) is
attached, the power tool movement is orbital.
ABRASIVE SANDING SHEET (Not provided)
CAUTION: Accessories must be rated for at least the speed recommended on the tool-warning
label. Accessories running over rated speed can fl y apart and cause injury. Accessory ratings must
always be above tool speed as shown on tool nameplate.
Assemble the abrasive sanding sheet (3) (Fig. 1) on the velcro surface of the backing pad (4). Press the abrasive
sanding sheet to attach it to the backing pad.
BATTERY PACK (Provided or Optional)
WARNING: Avoid short circuiting the contacts. Avoid mechanical damage of the battery pack. Do
not open or disassemble. Advice on protection against fi re and explosion. Keep away from open
fl ames, hot surfaces and sources of ignition.
Temperature in excess of 45°C reduce the performance of the battery pack. Avoid extended exposure to heat
or sunshine. Storage at room temperature (approx. 20°C) at approx. 20~60% of the nominal capacity. Every six
months of storage, charge the battery pack as normal.
Intended use
The battery pack 9HB125LT (Fig. 7) is used as the power source for Rupes Q-MAG NANO iBrid tool HQM83/
HQM83L.
Battery pack 9HB125LT speci fi cations
WARNING: for technical data refer to the label of Battery pack 9HB125LT. To reduce the risk of injury
or explosion, never burn or incinerate a tool’s battery pack even if it is damaged, dead or completely
discharged. When burned, toxic fumes and materials are created.