V1.0
RUNGU Electric Juggernaut LE User Manual
Copyright 2018 Standard Bearer Machines, LLC
11
16.
On a level surface, stand the Rungu upright and remove the packaging from the front steering
assembly, then remove the handlebars from the frame and packaging.
17.
Use the 5mm hex wrench to loosen the handlebar retention screws as shown below
18.
Insert the right and left handlebars into the stems. Rotate the handlebars vertically to ensure
the best fit for you.
19.
FOR STANDARD (NON SUSPENSION) FORKS: When you have found the best fit for each
handlebar, ensure that the inside end of each handlebar extends up to 30mm as depicted below
and then tighten all four retention screws. Use a pattern of tightening the upper screw and then
bottom screw instead of tightening both top screws and then the bottom screws.
20.
FOR OPTIONAL SUSPENSION FORKS: When you have found the best fit for each handlebar,
ensure that the inside end of each handlebar extends
45 mm
toward the center of the Rungu
and then tighten all four retention screws. Use a pattern of tightening the upper screw and then
bottom screw instead of tightening both top screws and then the bottom screws.
