Runco Video Xtreme CineWide VX-3000d, Руководство по эксплуатации

Страница: 56 / 114

Installation
42 VX-3000 Installation/Operation Manual
PRE
L
IMINAR
Y
Connecting to AC Power Projector: The VX-3000 ships with
various types of AC power cords.
Choose the one that is appropriate
to your locale.
Plug the female end of the power
cord into the AC receptacle on the
rear of the projector (AC 100V ~
240V). Then, connect the other end
to your AC power source.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a power source.
3.8
Turning on the Power 1. Turn on your source components.
2. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input (see above).
3. Turn on the main power switch at the rear of the projector. The POWER LED lights
orange. The LAMP and TEMP LEDs light red briefly, then go out.
4. Press the ON button on the remote control to turn on the VX-3000. The POWER LED
flashes green to indicate that it is warming up.
5. When the projector is ready for use, the POWER LED lights solid green.
6. “[Input Name] Source Searching” appears on the screen before the VX-3000 identifies
the input signal and remains there until a valid signal is detected.
➤
Power
switch
AutoScope Lens Motor (Rear)
AC Input
Power
Switch
to
110 VAC
Power