RUMBLE HOG RH7500, Руководство по эксплуатации

Страница: 97 / 164

97
Section 3 - operation
Don’ts
• Do not allow untrained personnel to operate
Rumble Hog equipment.
• Do not aim the laser guidance beam at any
person, vehicle or airplane.
• Do not operate the cutter with worn or miss-
ing teeth.
• Do not operate cutter with no water spraying
from nozzles.
• Do not allow the water tank to run dry during
operation.
• Do not make sharp turns while cutting.
• Do not back up with cutter down.
• Do not cut pavement on bridges, across inter-
sections or in front of driveways.
• Do not continue cutting if cutter is kicking back
or not cutting properly.
• Do not travel on the highway without centering
the cutter on the chassis.
• Do not travel on the highway without the lock-
ing arm in place and the latch secured.
• Do not travel on the highway with the cutter
articulation lock pins removed.
• Do not travel on the highway with the video
monitors mounted to the windshield or with
the laser guidance system activated.
3.16 milling (planing) operations
When beginning milling operations, you should
configure the cutter for planing which will lockout
the eccentrics and cancel cutter drum plunging.
Also, the gauge wheels must be reconfigured for
planing. Make sure down pressure is set for the
type of pavement to be cut.
Always set cutter down pressure, cutting depth
and the width of the cut. Then make several short
test runs to fine tune the settings. Make sure to
adjust down pressure if the gauge wheels grove
the pavement or the cutter kicks back while cut-
ting.
Use the following procedure to begin planing
operations.
Starting Planing Operations
1. Perform all steps Pre-Operation Inspection and
System Startup Procedure.
2. Align the truck according to procedures de-
scribed in Aligning Truck & Setting Cutter
Offset.
3. Activate optional vacuum system (if equipped
or desired). Main screen button # 4. Refer to
the Vacuum System Operation for instructions
to activate the vacuum system.
4. Activate optional continuous Off-loading Sys -
tem (if equipped or desired). Refer to the
Continuous Off-loading System Operation for
additional instructions to activate continuous
off-loading.
5. Press button #8 while holding the up arrow
on the control monitor to activate the Cutting
Drum rotation. (The Cutting Head must be in
UP position)
6. Lower the Cutting Head by pressing down ar-
row button
7. Activate FLOAT function. (Button on the right
side of a joystick)
8. Activate skip function (if necessary) by press-
ing button #6 on the control monitor.
9. Position Guidance camera (if desired). Refer
to “Guidance System Quick Start”
10. Using the hydrostatic drive, move the truck
forward a short distance (approximately
truck’s length). Stop and inspect the depth,
width, length of cuts and length of skips. Mi-
nor adjustment might be necessary to satisfy
demand of the job.
11. Press and hold one of the top buttons (button
1 or 2) on Remote-Control to raise the cutter
drum and pause the cutting function when
driving across intersections or driveways.
Release the button to lower the cutter drum
and resume cutting operations.