RUMBLE HOG RH7500, Руководство по эксплуатации

Страница: 95 / 164

95
Section 3 - operation
3.15 rumble Strip cutting operations
NOTICE:
THE CONTROLLER DISPLAY SCREENS SHOWN IN THIS
SECTION ARE FOR DEMONSTRATION PURPOSES ONLY. THE
DISPLAY AND CONTROLS IN THE CONTROLLER ON YOUR
TRUCK MAY BE DIFFERENT. REFER TO THE SUNSOURCE
HOG TECHNOLOGIES USER GUIDE FOR A DESCRIPTION OF
THE CONTROLS AND FEATURES.
1. Complete the “Setting Up the Drum Procedure”
2. Complete the “Unlock Lift Arm Procedure.”
3. Lower the Cutting Head to the ground.
4. Adjust the down pressure. (Refer to a section)
Pressure is displayed on the screen
A. Excessive pressure leaves undesirable wheel
marks.
B. Low pressure may allow the cutting head to
bounce and damage the teeth.
5. Adjust the trim pressure. (Refer to a section)
A. Excessive pressure leaves undesirable wheel
marks.
B. Low pressure may allow the cutting head to
bounce and damage the teeth.
6. Make sure the eccentric relief valve is set cor-
rectly. (Refer to a section)
7. Open the Water Supply Valve
8. Turn on the Charge Pump. (Button #5 on the
control monitor)
9. Use selector ball valve to direct water to the cut-
ting drum or into the vacuum head as desired.
Joystick, Joystick Trigger (A) & TRUCK SPEED Dial (B)
A
B
Controller MAIN Screen Control Buttons
Controller CUT SETUP Screen
10. Press button #2 (CUTTER) on the control Main
screen. This will take you to the Cut Set Up page.
11. Select between PRIMARY cut/skip or SECOND-
ARY cut/skip, buttons 7 or 8.
12. Enter the number of cuts and skips using up/
down arrow buttons.
13. Enter the percentage of Cutter Coil Signal to
set the spacing between each cut. During the
operation, the Actual Distance between cuts will
display in the right upper corner of the screen.
Use buttons 5(+) and 6(-) to adjust the distance.
These parameters will have to be readjusted
during operation.