RUMBLE HOG RH7500, Руководство по эксплуатации

Страница: 69 / 164

69 69
Section 2 - Rumble Hog Systems
Both conditions are programmed into the engine
ECM and are automatically selected with MODE
switch on the joystick panel. When the MODE
switch is on, it sends a signal to the transmis-
sion that tells it to select the pre-programmed
conditions when the operator puts it into drive.
Since one of the conditions is to lock the torque
converter, it is extremely important to turn the
MODE switch ON or OFF in the proper sequence
to avoid severe damage to the transmission and
torque converter. Refer to the Start-Up Procedure
in the Operation section of this manual for addi-
tional instructions.
2.20 access panels,
ladders & tool Boxes
Ladders
A ladder on the driver’s side of the unit provides
access to the components located on the chassis
between the water tank and the truck cab. The
ladder is hinged and has a spring loaded safety
pin that locks the ladder in the stored or deployed
position. To use the ladder, release the safety pin
and swing the ladder out until the pin locks in the
deployed position. Return the ladder to the stored
position and secure it with the safety pin when
service or inspections are complete.
Debris Tank Ladder
Another ladder on the passenger side of the debris
tank provides access to the top of the tanks. The
ladder is hinged and has a spring loaded safety
pin that locks the ladder in the stored position. To
use a ladder, release the safety pin and rotate the
ladder to the down position. Return the ladder to
the stored position and secure it with the safety
pin when service or inspections are complete.
CAUTION
ALWAYS MAKE SURE THE LADDERS ARE LATCHED IN THE
STORED POSITION BEFORE OPERATING THE TRUCK. THE
LADDERS STICK OUT FROM THE SIDE OF THE VEHICLE AND
CAN CAUSE DAMAGE TO THE TRUCK OR OTHER VEHICLES
IF THEY ARE NOT PROPERLY SECURED FOR TRANSPORT.
Debris Tank Ladder
Driver’s Side Ladder