RUMBLE HOG RH7500, Руководство по эксплуатации

Страница: 15 / 164

15
Section 1 - Safety Information
Product changes
Hog Technologies is committed to the continuous
improvement of our products. As a result, some
of the equipment described in this manual or
pictured in the catalog may change or no longer
be available.
All information, illustrations, and specifications
contained in this manual are based on the lat-
est product information available at the time of
publication. Hog Technologies reserves the right
to make changes at any time, without notice, in
colors, materials, equipment, specifications, and
models.
If you have questions about the equipment on
your Rumble Hog, please contact the Customer
Support Department at (877) HOG ROAD or (001)
(772) 214-1714.
Never Alter a Hog Technologies Product
Do not alter any product without written consent
from the manufacturer. Any alterations could have
serious consequences including bodily harm or
death. Alterations without manufacturer consent
will void the warranty.
Inspect Equipment
Inspect the condition of all components prior to
use. Do not use any item that is in questionable
condition.
IMPORTANT NOTE:
YOUR EQUIPMENT USES AN INTERNAL COMBUSTION
ENGINE AND FLAMMABLE FUEL. EVERY PRECAUTION HAS
BEEN TAKEN BY HOG TECHNOLOGIES TO REDUCE THE
RISKS ASSOCIATED WITH POSSIBLE INJURY AND DAMAGE
FROM FIRE OR EXPLOSION, BUT YOUR OWN PRECAUTION
AND GOOD MAINTENANCE PROCEDURES ARE NECESSARY
TO ENSURE THE SAFE OPERATION OF YOUR EQUIPMENT.
Store Components Properly
Protect all components from damage when not in
use. Always secure the lift arm and cutter chassis
for transit.
1.3 operation & cutter Safety
Safety Rules and Statements
Before operating or performing any maintenance
on the vehicle, review the following safety pre-
cautions. These are included for your protection
and safety.
Always observe the general safety rules during
operation of the vehicle. Also observe the safety
rules set forth in the work place. The need for ad-
ditional rules for safe operation may arise due to
particular applications. The following safety rules
should only be used as a general guide.
• Perform all recommended checks and report
all vehicle defects.
• Check the area around entire vehicle prior to
operation.
• Make sure all bolts, nuts, screws and other
fasteners are in place and tight. All fasteners
should be inspected frequently and replaced or
tightened as required.
• Recognize and avoid potential hazard areas,
such as the cutter (especially the teeth), lift
arm, lift area, etc. The operator and passengers
must be seated in proper seats with seat belts
fastened during operation.
• Do not operate equipment while under the
influence of alcohol or drugs.
• Ensure that all instruments, indicators and op-
erating controls are functioning properly before
operating the truck or cutter.
• Do not allow pedestrians near the vehicle when
cutter is in operation.
• Always make sure the cutter chassis is centered
and secured in the lifted position with the lock-
ing arm before driving the truck on the highway.
This will insure proper weight distribution, avoid
unexpected lowering of the grinding chassis and
equipment damage.
• Never work on the cutter or lift arm unless it is
secured with the locking arm in the up position
and/or supported with safety stands.
• Always secure the cutter arm in the full up
position with the locking arm when the vehicle
is parked.
• Operate vehicle with caution. Be aware of your
surroundings.