Ruijie RG-S2900 Series, Руководство по установке

Страница: 19 / 27

Hardware Manual Chapter 3 Product Installation
3-5
Figure 3-5 Installing hangers
There are screw holes on the hanger, during the installation, press the hanger onto the side
wall of the switch.
3.4
Checking After Installtion
Note
Before checking the installation, switch off the power supply so as to avoid any
personal injury or damage to the component due to connection errors.

Check that the ground line is connected.

Check that the cables and power input cables are correctly connected.

Check that all interface cables are laid out inside the equipment room. In the case of
external cabling, check that the lightning resistance socket or network interface
lightning protector is connected.

Check that sufficient air flow is available around the device (over 10cm).
3.5
Precautions

Place the switch stably.

Confirm the consistency of the supply electricity and the power supply requirements of
the switch.

The switch enclosure shall not be opened to prevent the danger of electric shock.
Neither shall you open the enclosure by yourself even if the switch is not powered on.

If the switch is connected with the working station, server, HUB or other switches, the
switch uses the UTP or STP network cable, which is up to 100m.

For 10-Base-T Ethernet, use the cable of Category-3 or higher UTP or STP.

For 100-Base-TX Ethernet, use the cable of Category-5 UTP or STP.