Cutting Centre SR 2 BiTurbo
11
2.3
Connecting the machine
The machine is connected to a three-phase outlet (clockwise rotating
field), the specifications (voltage, amperage) must correspond to the
specifications on the type plate of the machine.
The machine must be shut down until a damaged power
supply line has been repaired!
Check the power supply line regularly!
Check the correct direction of the rotary field by starting
the machine. A message appears on the tablet PC if the
rotating field is wrong!
•
In this case, an electrician has to change the rotating
field inside the mains plug.
•
The power supply to the machine must be fuse-pro-
tected with 16 A and protected with an AC/DC sensi-
tive RCD (type B).
3
Operating instructions
Please refer to the short instructions supplied with your machine for
the operation of your cutting centre.
Also follow the safety instructions in chapter 1.1!
Make sure that you are connected to the right machine
with your tablet PC!
In its respective life cycle phases (transport, commission-
ing, setup, operation, cleaning, decommissioning,
care/maintenance, dismantling/disposal) this machine is
designed for single person operation!
When using this machine, no other person may be present
near the machine. The exception (2-man operation):
•
Transport of machine and machine parts
