Cutting machine SR 1 / SR 1 Turbo
14
5.1
Regular care
Regular care of the machine must be carried out at least once per
week. This prevents malfunctions and signs of wear.
Any abnormalities detected during regular care must be reported to
the supervisor! He must immediately initiate correction or
maintenance or notify Rühle Service!
Care schedule:
a)
Disassemble the machine according to the cleaning
instructions. Check for any parts moving with difficulty,
material abrasion or other signs of wear and tear.
b)
Remove the cut-off knives with the knife sharpener and
check them for any damage or broken blades.
c)
Sharpen the grate knives in the knife levels with the knife
sharpener and check them for any damage or broken blades.
Grate knives must be resharpened at least every 50
working hours on a slip-resistant underlay using only little
pressure and a Rühle knife sharpener!
d)
Check the slider (funnel closure) and its guide pins for
damages and abrasion; remove sharp edges!
e)
Check the guide rails of the slider (funnel closure) in the
machine and the grate frame; remove sharp edges!
f)
Check the rollers of the eccentric shafts (drive shaft for the
knife level) and of all grate frames:
a.
For easy running and axial play!
b.
For abrasion (plane surfaces)!
Replace defective rollers!
In case of abrasion, check the corresponding sliding
surface on all knife levels for damages!
Replace defective knife levels!
g)
Visually check for changes or damages on all machine sides
and accessible machine parts, e.g. the knife levels. The
