9. SNMP
ROX™ v2.2 User Guide
109
RuggedBackbone™ RX5000
UDP Port for the remote target to receive traps on(default 162).
Security Model
Synopsis: string - one of the following keywords { v3, v2c, v1 }
Default: v2c
The SNMP security model to use: SNMPv1, SNMPv2c, or USM/SNMPv3
User Name
Synopsis: string
The user name to be used in communications with this target.
Security Level
Default: noAuthNoPriv
The SNMP security level:
• authPriv: communication with authentication and privacy.
• authNoPriv: communication with authentication and without privacy.
• noAuthnoPriv: communication without authentication and privacy.
Control Community
Synopsis: A string
Restrict incoming SNMP requests from the IPv4 or IPv6 address associated with this community.
Trap Type List
Default: snmpv2_trap
Selects the type of trap communications to be sent to this target
Inform Timeout
Default: 6000
The timeout used for reliable inform transmissions (seconds*100)
Inform Retries
Default: 3
The number of retries used for reliable inform transmissions
Target Engine ID
Default:
The target's SNMP local engine ID. This field may be left blank.
9.7. SNMP Users
These parameters provide the ability to configure users for the local SNMPv3 engine. Note that, if
the security level employed is SNMPv1 or SNMPv2, User Name represents a community name for
authentication or sending traps. Up to 32 entries can be configured.
Figure 9.13. SNMP User Configuration table
The path to the SNMP User Configuration table is admin/snmp/snmp-user.
