RuggedCom RSG2488, Руководство пользователя

Страница: 82 / 194

Chapter 3
Device Management
RUGGEDCOM RSG2488
User Guide
70 Resetting Ethernet Ports
Parameter Description
• OFF - Turning this parameter OFF will disable FAST LINK DETECTION completely.
The switch will need a longer time to detect a link failure. This will result in a longer
network recovery time of up to 2s.
Link Detection Time Synopsis: 100 ms to 1000 ms
Default: 100 ms
The time that the link has to continuously stay up before the "link up" decision is made
by the device.
(The device performs de-bouncing of Ethernet link detection to avoid multiple responses
to an occasional link bouncing event, e.g. when a cable is shaking while being plugged-
in or unplugged).
3. Click Apply .
Section 3.7.9
Resetting Ethernet Ports
At times, it may be necessary to reset a specific Ethernet port, such as when the link partner has latched into an
inappropriate state. This is also useful for forcing a re-negotiation of the speed and duplex modes.
To reset a specified Ethernet Port(s), do the following:
1. Navigate to
Ethernet Ports > Reset Port(s) . The Reset Port(s) form appears.
1
2
Figure 30: Reset Port(s) Form
1. Ports 2. Apply Button
2. Select one or more Ethernet ports to reset.
3. Click
Apply . The selected Ethernet Ports are reset.
Section 3.8
Managing IP Interfaces
Two types of IP interfaces can be configured in :
• Management IP interfaces
• Switch IP Interfaces
The management IP interface represents the management port on the device. Only one management IP interface
can be configured.
Switch IP interfacers may be configured for each subnet (or VLAN), up to a maximum of 255 interfaces.
Each IP interface must be assigned a static IP address and subnet.