Tools Needed:
• 10mm end wrench
• Tape measure
• 8mm end wrench
• Hot knife (we use a Demand Part #HKTCR but most hot knives should work)
• 7mm end wrench
• Screwdriver
RZR PRO XP MOUNT
INSTALLATION GUIDE
NOTE: Please read Rugged Radios Installation guide before installing your communication system:
https://www.ruggedradios.com/PDF/Installation-Tech-Guide.pdf
Step 1: Pull rubber mat out of center
console. There are 6 rubber tabs holding it
in the console that can be a bit stubborn
to remove.
Step 2: Using a hot knife, cut the center of
the console out. Be very cautious when
cutting the bottom of the console
because the 12v power socket cable
runs under it.
Step 3: Cut a 5”x 4” hole in the lower panel
making the first cut 3” forward of the edge
of the cup holder. This will allow the
cables on the back side of the intercom
clearance and allow it to be serviced.
Step 4: Knock out the round accessory
plug in the back of the console cubby.
This hole will be used to run your Push to
talk buttons and the Antenna Coax cable
through when the mount is installed.
Step 5:
a) Assemble the mount with radio, intercom and the 12v power socket.
b) Run power cables down the center console on the drivers side of the shifter and under
the seat to the battery. Secure them well with zip ties.
c) Run the driver, co-driver and rear seat helmet/headset cables down the console on the
passenger side of the shifter and to their specific seat. Secure cabling with zip ties but do
not over tighten them.
d) Run Push to talk cables and Antenna cable through round socket hole
e) Connect all cables to their appropriate location on the radio and intercom
f) Don’t forget to plug in the 12v power supply!
5”
4”
3”
Rugged Radios | www.ruggedradios.com | 888-541-7223
